Braking Method Of Water Ring Vacuum Pump
Feb 01, 2023
Water ring vacuum pumps are currently widely used and have a wide range of effects. For the entire equipment, it is a device that can pump water and air, and operates by pressure. Its braking method will be introduced in the following content:
1. Regenerative braking: when the water ring vacuum pump decelerates or stops, the energy generated by the braking is fed back to the DC bus through the inverter circuit, and absorbed by the resistance-capacitance circuit. The regenerative braking must work when the server is working normally. , The motor cannot be braked in the event of failure, emergency stop, power failure, etc., and the work is performed automatically by the system.
2. Electromagnetic brake: the shaft of the SK water ring vacuum pump is locked by a mechanical device. The electromagnetic brake is generally activated after SV and OFF, otherwise the amplifier may be overloaded. The dynamic brake is generally activated after SV, OFF or the main circuit is powered off. Otherwise, the dynamic braking resistor may overheat.
3. Dynamic brake: It is composed of dynamic braking resistors, which shortens the mechanical feed distance of the water ring vacuum pump through energy-consuming braking during failure, emergency stop, and power failure. The dynamic brake does not need power when it works, but needs external relay control.
The water ring vacuum pump will apply some suitable braking methods during some operations. These braking methods will have a positive impact on the use of the pump and can effectively improve efficiency. strengthen their role.






