Call Us: +8613573317266Email: 947633108@qq.com
enLanguage

Brief Introduction Of Double Suction Split Pump

Oct 19, 2022

Sap double suction split pump structure diagram. 6. If the water pump is installed above the water inlet level, in order to fill and start, the bottom valve should be installed, or the vacuum water diversion method can be used. Place the split face paper pad, cover the pump cover, tighten the taper pin of the screw tail, and then tighten the pump cover nut. For rolling bearings, except 100dk230 and 250dk240 pumps, which are lubricated with thin oil, the rest are lubricated with grease, and 250dk360 pumps are lubricated with thin oil for sliding bearings in forced rotation (equipped with thin oil station). The pump shaft is supported by two bearings, which are installed in the bearing body and lubricated with grease at both ends of the pump body. When the liquid flows from the impeller center to the outer edge, an inevitable vacuum is formed in the impeller center. Because the pressure above the liquid level of the storage tank is greater than the pressure at the pump inlet, the liquid is continuously pressed into the impeller. It has excellent anti cavitation function, stable operation and long service life.




The xxxx xx stainless steel double suction split pump is turned clockwise, that is, the suction inlet is on the right and the discharge outlet is on the left. The water pump is directly driven by the electric actuator through the coupling. Assembly of rotor parts: for the packing pump, install the impeller, shaft sleeve, shaft sleeve nut, packing ring, packing gland, water retaining ring, bearing parts, and double suction seal ring, and then install the coupling. When the packing is worn, the packing gland can be properly pressed, and if it is worn too much, it should be replaced. The pump body and the pump cover form the working room of the impeller. The inlet and outlet flanges are provided with pipe screw holes for installing vacuum gauges and pressure gauges, and the lower part of the inlet and outlet flanges is provided with pipe screw holes for draining water. Then fill all anchor bolt holes with concrete.




The purpose of dk double suction split pump torsion mark is generally seen from the motor end. 250dk240250dk360 pump is turned counterclockwise, that is, the suction inlet is on the left and the discharge outlet is on the right. When stopping the operation of the water pump, first block the cocks of the vacuum gauge and pressure gauge and the gate valve on the outlet pipe, and then block the power supply of the electric actuator. If the temperature is low, open the square screw plug at the lower part of the pump to remove the remaining water to avoid frost cracking. Under the influence of centrifugal force, the liquid is thrown to the outer edge from the center of the impeller and gets energy, which separates the outer edge of the impeller at high speed and enters the volute pump housing. The basic size shall be suitable for the installation size of the pump unit. Tighten the compression nuts on the packing gland evenly to make the liquid leak out in drops, and pay attention to the temperature rise at the packing chamber. b. If only normal flow is given in the production process, certain allowance should be considered. During operation, if noise or other abnormal sounds are found, it is reasonable to stop the machine immediately, check the causes and eliminate them. The installation height of the water pump, together with the hydraulic loss of the suction pipe and its speed, shall not be greater than the allowable suction vacuum height specified in the sample. For the mechanical seal pump, install the impeller, shaft sleeve, mechanical seal retaining sleeve, mechanical seal moving ring, static ring, mechanical seal gland, bearing components in turn, and cover the double suction seal ring, and then install the coupling.