Reasons For The Slow Vacuum Pumping
Aug 17, 2022
The rotary vane pump is mainly composed of pump body, rotor, rotary vane, end cover, spring, etc. A rotor is eccentrically installed in the cavity of the rotary vane pump, the outer circle of the rotor is tangent to the inner surface of the pump cavity (there is a small gap between the two), and two rotary vanes with springs are installed in the rotor groove. During rotation, the top of the rotary vane is kept in contact with the inner wall of the pump chamber by centrifugal force and the tension of the spring, and the rotor rotates to drive the rotary vane to slide along the inner wall of the pump chamber.
The two rotary vanes divide the crescent-shaped space enclosed by the rotor, the pump chamber and the two end covers into three parts, A, B, and C, as shown in the figure. When the rotor rotates in the direction of the arrow, the volume of the space A communicating with the suction port is gradually increasing, and the suction process is in progress. And the volume of the space C communicated with the exhaust port is gradually shrinking, and it is in the process of exhausting. The volume of the central space B is also gradually reduced, and is in the process of compression. Since the volume of space A is gradually increased (ie, expanded), the gas pressure is reduced, and the external gas pressure at the inlet of the pump is stronger than the pressure in the space A, so the gas is sucked in.
When space A is isolated from the suction port, that is, it turns to the position of space B, the gas begins to be compressed, the volume gradually shrinks, and finally communicates with the exhaust port. When the compressed gas exceeds the exhaust pressure, the exhaust valve is pushed open by the compressed gas, and the gas is discharged into the atmosphere through the oil layer in the fuel tank. The purpose of continuous pumping is achieved by the continuous operation of the pump. If the exhausted gas is transferred to another stage (low vacuum stage) through the air passage, it is pumped away by the low vacuum stage, and then compressed by the low vacuum stage and then discharged into the atmosphere, which constitutes a two-stage pump. At this time, the total compression ratio is borne by two stages, thereby increasing the ultimate vacuum.






